The following paragraphs describe the operating procedures for a CMM5 Injector in standalone mode (Controller not present).
Note: When a Controller is present the Injector operations can be run entirely from the Controller GUI interface. (Refer to the CMM5 Controller Operation section for details.)
Perform the following steps to cause the Injector port LEDs to blink which can be used to quickly verify communication with the Injector:
|
Step |
Action |
|
1 |
Run the TeraTerm terminal emulator and start a serial session to the Injector COM port. |
|
2 |
Execute the following query command to blink the Injector LEDs: &0w |
|
3 |
The green and red LEDs will illuminate for one second on each of the four ODU ports will illuminate for one second.
|
: