I have a few R190W Cnpilots that I'm trying to setup for some customers that have other ISP's. They are either on Cable or DSL, so they need to have their existing modem do the routing for them. I"m trying to get these R190's to work as AP/Switches. I have followed the instructions I found here: http://community.cambiumnetworks.com/t5/cnPilot-R-Series-Home-Small/Router-vs-Access-Point-Mode/td-p/52439 with no luck. I can see the router in CnMaestro, but it won't pass traffic to the lan ports or out the wireless side. Does the LAN IP have to be set to the same range as the local network address manually?
I've attached screenshots of the settings I'm using.
- management-voice.PNG (13.1 KB)
- internet.PNG (19.8 KB)