How to config burst rates

Products ePMP
1

Hello

I would like to know how to configure Burst rates on the epmp1000 2.4ghz, I know how to do all my QOS stuff, Just would like to see if i can set the burst rates a little higher when a speedtest is ran/wireless link test.

2

SW VER 2.6.1 on all radios

3

Burst rates are currently not supported in QoS on ePMP... yet...

1 Like
4

thanks

Eric

5

I would like to know how to configure Burst rates on the epmp1000 2.4ghz,  

Hi.  This idea has been posted in the 'your idea' area - so everyone make sure to VOTE.

http://community.cambiumnetworks.com/t5/Your-Ideas/qos-with-burst-for-epmp/idi-p/39923
6

Apparently, the QOS won't be supporting a burst type of rate limiting.  The status was changed to ''not in development plan'

http://community.cambiumnetworks.com/t5/Your-Ideas/qos-with-burst-for-epmp/idi-p/39923

Cambium - so does this refer just to the OP's specific request, or does it mean that there's no plans for any and all manners of quotas and burst and fallbacks and anything along the lines of variable QOS speeds based on data usage, time of day, quota-per-time-period and all those types of options?