How to convert an existing PTP800/810 antenna for PTP820 direct mount?

Products PTP
1

For all PTP800/810 direct mount antenna, we offer a solution which can convert the antenna to PTP820 direct mount, so customer will be re-use the same antenna, no alignment need.

First, you will need order the PTP820 interface plate depends on which frequency the antenna is:

N060082L004A PTP 820 RFU-C interface plate for 6GHz ( CR4)
N070082L003A PTP 820 RFU-C interface plate for 7GHz ( CR4)
N110082L003A PTP 820 RFU-C interface plate for 11GHz ( CR4)
N130082L003A PTP 820 RFU-C interface plate for 13GHz ( CR4)
N150082L001A PTP 820 RFU-C interface plate for 15GHz ( CR4)
N180082L001A PTP 820 RFU-C interface plate for 18GHz ( CR4)
N230082L001A PTP 820 RFU-C interface plate for 23GHz ( CR4)
   

Then you will need follow these steps:

Step 1: Remote the PTP800 ODU interface plate

IMG_2186.JPG
IMG_2186.JPG2448×3264 1.78 MB
IMG_2191.JPG
IMG_2191.JPG3264×2448 1.72 MB

Antenna with PTP800 ODU interface plate

after the interface plate removed

Step 2: install the PTP820 interfece plate follow the Andrew installation procedure (attachement)

Regards

Allen

1 Like
2

Hello Allenyu! Does it work for another antenna makers? I see the part is Andrew but I'm using RadioWaves antennas.

Regards

3

Does this link answer your question?

http://community.cambiumnetworks.com/t5/Licensed-Microwave/Re-Use-Existing-Antennas-for-PTP820/m-p/84401

:)

I hope this helps!

Dave

4

Hehe! Yes, partially! Thanks! I only see for 11 & 18 GHz on RadioWaves. There's no 23 GHz?

5

Unfortunately there is no convert for 23 GHz today. It could be done but overall the demand is very low so far.

Regards

Allen