The following paragraphs describe planning for the CMM5 module and cabling.
Injector Cabling
The following table describes Injector cables.
Table 5 CMM5 Power and Sync Injector Cables
|
Nomenclature |
Function |
Cable Required |
|
PRIMARY |
Primary 48VDC |
Power connector |
|
SECONDARY |
Optional Secondary 48 VDC input for backup/resilience |
Power connector |
|
TO RADIOS |
To Access Points |
RJ-45 connector |
|
TO SWITCH ARRAY |
To Network |
RJ-45 connector |
|
OUT |
Sync signal out |
RJ-12 connector |
|
IN |
Sync signal in |
RJ-12 connector |
|
UGPS |
uGPS or cnPulse |
RJ-12 connector |
|
USB |
Daisy Chain other Injectors |
USB Female |
Controller Cabling
The following table describes Controller cables.
Table 6 CMM5 Controller Cables
|
Nomenclature |
Function |
Cable Required |
|
NETWORK |
To Network |
RJ-45 |
|
USB |
Daisy-Chain Controllers |
USB |
|
48 – 56 VDC |
DC Power Input |
Power connector |
Injector Front Panel
CMM5 Cable Requirements
|
Nomenclature |
Function |
Cable Required |
|
PRIMARY |
Primary 48VDC |
Power connector |
|
SECONDARY |
Optiona: Secondary 48 VDC |
Power connector |
|
TO RADIOS |
To Access Points |
RJ-45 connector |
|
TO SWITCH ARRAY |
To Network |
RJ-45 connector |
|
OUT |
Sync signal out |
RJ-12 connector |
|
IN |
Sync signal in |
RJ-12 connector |
|
UGPS |
uGPS or cnPulse |
RJ-12 connector |
|
USB |
USB Female |
The following graphic shows a fully cabled Injector/Controller combination with Ferrite beads for EMI suppression.
Injector/Controller Combination Cabling
