Is it Mesh or Me?

Two r190x/r201x/r200x can be connected through the wireless link by two ways.

  1. WDS (Wireless 2.4GHz-->WDS) Mesh Repeater mode.
  2. AP-Station (Wireless 2.4GHz-->Repeater mode) Repeater Mode.
  1. WDS (Wireless 2.4GHz-->WDS) Mesh Repeater mode:

Please do not use the  WDS Repeater mode(Wireless 2.4GHz-->WDS)   as there is known the issue of low throughput in the current image (4.3.4r8) and refer below KB.

https://community.cambiumnetworks.com/t5/cnPilot-R-Series-Home-Small/R200-201-WDS-mode-setup-guide/m-p/74457#M31

  1. AP-Station (Wireless 2.4GHz-->Repeater mode) Repeater Mode.

     The user can use this as Wi-Fi Range Extender.  

    Using this mode, the user can connect as follows.

  1. R-Series AP <-> R-Series AP.
  2. E-Series AP<->R-series AP.
  3. Any wireless AP<–>R-series AP.
  • AP-Station Repeater mode  in-between  R-Series  APs(R-Series AP <-> R-Series AP).

Network topology:

 

 Procedure:

  1. Configure the Base AP and Repeater client AP in Default Mode.
  2. Configure the SSID, Security mode and key in the Base AP (Wireless-Security and Wireless->basic).
  3. Configure and enable  Repeater mode in the repeater client AP and refer the below screenshot.

 4. Configure the Repeater client AP in the bridge in network section page and refer below screenshot

 5. Connect the Repeater client AP to SSID of  Base AP, refer below screenshot.

 


  • AP-Station Repeater mode  in-between  R-Series  and  E-Series AP (E-Series AP<->R-series AP).

Please refer below KB.

Path: https://community.cambiumnetworks.com/t5/cnPilot-R-Series-Home-Small/Wi-Fi-Range-Extender-between-cnPilot-R-and-E-Series-Access-Point/m-p/73717#M30

Please let me know if you have any query.

Regards

Niraj

4 Likes