R200/201P Bricked recovery oprions

I have over 20+ of these units that are in a locked state.

It begins its intial startup  then all lights stay on.

I know I cannot be the only one having seen this.

since the cost of replacement is cheaper than sending them in I have taken a few and started

to investigate options for recovery if possible.

I have noticed there are 5 pins located on the pcb. Is there a special interface needed for this to be able to

upload a new image to reflash the broken image?


Could you please confirm if you have tried to Reset the devices using the Hard reset procedure:


Also tried using the ATA Analog Phone reset procedure : 



Harish Krishna